Invacare CROSSFIRE T6 User Manual download pdf (Page 55)

SECTION 9—WHEEL LOCKS

Part No 1148078 55 Crossfire™Series Wheelchairs

SECTION 9—WHEEL LOCKS

 WARNING

After any adjustments, repair or service and before use, make sure all attaching

hardware is tightened securely - otherwise injury or damage may result.

Replacing/Adjusting the Wheel Locks

 WARNING

If wheel locks do not hold the occupied wheelchair in place contact a qualified tech-

nician - otherwise injury or damage may occur.

NOTE: For this procedure, refer to FIGURE 9.1 on page 56.

NOTE: Before adjusting or replacing wheel locks, ensure that the tyres are inflated to the

recommended psi on the sidewall of the tyre.

Replacing the Wheel Lock

1. Remove the two mounting screws and remove the existing wheel lock from the

wheelchair.

2. Using the two mounting screws, install the new wheel lock. Securely tighten.

Adjusting the Wheel Lock

1. Engage the wheel locks.

NOTE: Any wheel lock adjustment should embed the wheel lock shoe at least 3/16-inch (.47 cm)

into the pneumatic tyre (1/8-inch (.32 cm) for urethane wheels) when engaged.

2. If necessary, loosen the two mounting screws that secure the wheel locks to the

wheelchair frame and adjust position of the wheel lock until the 3/16-inch (.47 cm)

(1/8-inch (.32 cm) for urethane wheels) measurement is obtained for correct wheel lock

adjustment.

3. Securely tighten the two mounting screw(s).

4. Engage the wheel locks and push against the wheelchair and determine if the wheel

locks engage the wheel locks enough to hold the wheelchair.

5. Repeat the above procedures until the wheel locks hold the wheelchair.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60

No comments

Invacare CROSSFIRE T6 User Manual Page 55