Invacare Top End Terminator Jr. User Manual download pdf (Page 27)

WHEELS PROCEDURE 7

WARNING

During contact activities, Invacare recommends

inserting quick-release axles with the head end

to the inside of the wheelchair to prevent acci-

dental release.

5. If there is too much movement of the rear wheel as-

sembly in a back and forth motion, refer to

ADJUST-

ING QUICK-RELEASE AXLES or ADJUSTING

QUAD-RELEASE HANDLES in this procedure of the

manual.

ADJUSTING QUICK-RELEASE

AXLES (FIGURE 2)

1. Remove rear wheel and quick-release axle from the

wheelchair. Refer to

REMOVING/INSTALLING

REAR WHEELS in this procedure of the manual.

2. Depress detent pin in the quick-release axle and slide

axle through the wheel hub.

3. Release detent pin ensuring that the locking pins are

fully released.

4. Increase or decrease end play by adjusting the lock-

nut on the end of the quick-release axle.

5. Reinstall rear wheel onto the wheelchair. Refer to

REMOVING/INSTALLING REAR WHEELS in this

procedure of the manual.

FIGURE 1 - REMOVING/INSTALLING REAR WHEELS

Quick-Release

Axle

Wheelchair

Frame

WARNING

After ANY adjustments, repair or service and BEFORE

use, make sure all attaching hardware is tightened

securely - otherwise injury or damage may result.

FIGURE 2- ADJUSTING QUICK-RELEASE AXLES

Adjustable Axle Position

Camber Bar

NOTE: End of Quick

Release axle is shown

for reference only. It is

not visible when

inserted into camber bar

Locking

Pins

Quick

Release Axle

Locknut

Wheel

Hub

Detent

Detent Pin

Locking Pins

NOTE: Quad-Release Axle not shown. Locking pins the

same as Quick-Release Axle

Rear Wheel

This Procedure includes the following:

Removing/Installing Rear Wheels

Adjusting Quick-Release Axles

Installing Quad-Release Axles

Adjusting Quad-Release Handles

Handrim Replacement

Repairing/Replacing Rear Wheel, Tire/Tube

Opening/Closing Clamps

Adjusting Rear Wheel Camber

Determining/Adjusting Toe in/Toe out

Adjusting Wheelbase Length

Adjusting Wheelbase Width

Replacing Axle Tube

Repositioning the Axle Tube

Repositioning/Replacing Front Casters

Adjusting Front Caster Height

Wheel Lock Adjustment/Replacement

REMOVING/INSTALLING REAR

WHEELS (FIGURE 1)

CAUTION

Changing the size of the rear wheels can affect

the performance of the wheelchair. Contact In-

vacare at the telephone numbers on the back

of this manual BEFORE changing rear wheel size.

1. Perform one (1) of the following:

QUICK-RELEASE - Push in the tip of the quick-release

axle and pull axle and wheel away from the wheelchair.

QUAD-RELEASE - Lift UP on the handle of the quad-

release axle and pull axle and wheel away from the

wheelchair.

2. Repeat STEP 1 for the opposite rear wheel.

3. Reinstall the rear wheels onto the wheelchair by re-

versing STEPS 1-2.

WARNING

Pull on the rear wheel to make sure the detent pin

and locking pins of the quick/quad-release axle

are fully released BEFORE operating wheelchair.

Keep locking pins clean.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

Comments to this Manuals

No comments

Invacare Top End Terminator Jr. User Manual Page 27

Comments to this Manuals

Related products and manuals for Computer desks Invacare Top End Terminator Jr.