Invacare Top End X-Terminator QR User Manual download pdf (Page 43)

SECTION 5—WHEELS

Part No 1114851 43 Everyday and Sport Series Wheelchairs

FIGURE 5.8 Determining Toe In/Toe Out - Measuring Centerlines of Rear Wheels

Adjusting Toe In/Toe Out

Camber Tube 2000

NOTE:Forthisprocedure,refertoFIGURE 5.9.

1. Openthecamberclamps.RefertoOpening/ClosingCamberClampsonpage 39.

2. Slowlyrotatethecambertubeineitherdirectionuntiltherearwheelsare

approximatelyinastraightline.

3. Closethecamberclamps.Referto

Opening/ClosingCamberClamps

on

page 39.

4. Measurethedistancebetweenthe

centerlinesattherearandfrontofthe

rearwheelsatapproximately12inches

fromtheground/floor.Referto

DeterminingToeIn/ToeOut

on

page 42.

5. RepeatSTEPS1‐4untilthetoein/toe

outmeasurementislessthan1/2‐inch

(0+1/4‐inchformaximumrollability).

FIGURE 5.9 Adjusting Toe In/Toe Out -

Camber Tube 2000

Front of Wheelchair

12-inches

Rear of

Wheelchair

Centerlines of Rear Wheels

Front of Wheelchair

Top View of Wheelchair

Smaller than

Front

Larger than Front

Toe-out

Toe-in

Top View of Wheelchair

Camber Tube - Rotates Up and Down

Camber Clamps

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 75 76

No comments

Invacare Top End X-Terminator QR User Manual Page 43