Invacare Top End X-Terminator QR User Manual download pdf (Page 70)

SECTION 8—SUSPENSION

Everyday and Sport Series Wheelchairs 70 Part No 1114851

SECTION 8—SUSPENSION

 WARNING

After ANY adjustments, repair or service and before use, make sure all attaching

hardware is tightened securely - otherwise injury or damage may occur.

NOTE:ThefollowingproceduresareforwheelchairswiththesuspensionoptionONLY.

Elastomers and Suspension

NOTE:Theperformanceofthewheelchairwillbeaffectedifelastomersarenotthesameonboth

sidesofthewheelchair.

Replacing Rear Elastomers

NOTE:Forthisprocedure,refertoFIGURE 8.1.

1. Useanallenwrenchtoholdtheouterallenscrew.

2. Whileholdingtheouterallenscrewinposition,removetheinnerallenscrewfromthe

pivotpin.

3. Usetheallenwrenchtopushthepivotpinwithouterallenscrewoutofthemounting

hole.

4. Removetheexistingelastomer.

5. Positionthenewelastomerbetweentherecessintheaxlebracketandtherecessinthe

suspensionbase.

6. Compressandholdtheelastomerbetweentheaxlebracketandthesuspensionbase.

7. Insertthepivotpinintothemountinghole.

8. Installtheouterallenscrewintothepivotpin.

9. Useanallenwrenchtoholdtheouterallenscrewinposition.

10. Whileholdingtheouterallen screw,installtheinnerallenscrewintothepivotpin.

Tightensecurely.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 76

No comments

Invacare Top End X-Terminator QR User Manual Page 70