Invacare TRACER EX2 User Manual download pdf (Page 53)

10 ANTI-TIPPERS/WHEEL LOCKS

Part No 1110546 53 Invacare

Tracer™ EX2 Wheelchair

5. If the distance between the bottom of anti-tipper wheels and the ground/floor is not 1

to 2 inches, adjust anti-tippers. Refer to Adjusting the

Anti-Tippers on page 53.

Adjusting the Anti-Tippers

1. Place the wheelchair on a flat surface.

2. Press the release buttons on the wheeled portion of the anti-tipper

and slide it up or down to the desired adjustment hole.

3. Check to make sure that the release buttons are fully engaged in

adjustment holes.

4. Ensure both anti-tippers are adjusted to the same height.

5. Measure the distance between the bottom of the anti-tipper wheels

and the ground/floor.

6. If the distance between the bottom of anti-tipper wheels and the

ground/floor is not 1

to 2 inches, repeat steps 2-5 until the

distance is 1

to 2 inches.

7. If the 1

to 2 inch distance cannot be achieved, a different model

may be required. Contact an Invacare dealer or qualified technician.

FIGURE3 Adjusting the Anti-Tippers



A 1

to 2 inch clearance between the bottom of the anti-tipper wheels and the ground/floor MUST be maintained at all times.



A 1

to 2 inch clearance between the bottom of the anti-tipper wheels and the ground/floor MUST be maintained at all times.



If adjusting anti-tippers on recliner models, ensure back

canes are in the upright position before making

adjustments.

Release Buttons

to 2 inch Clearance

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 63 64

No comments

Invacare TRACER EX2 User Manual Page 53