Invacare GET-U-UP LIFT User Manual download pdf (Page 11)

SECTION 2—ASSEMBLY

Part No 1148115 11 Get-U-Up

™

Lift

Attach the Horn to the Mast and

Actuator

NOTE:Forthisprocedure,refertoFIGU RE 2.2.

1. Alignthehornbushingwiththeholesinthehorn

mountinglugsonthemast.

2. Attachthehorntothemastwith ashoulderbolt,twoste el

w ashers,twonylonwashersandalocknut.

NOTE:Thenylonwash ersMUSTbeinstalledbetweenthehorn

bushing

andhornmountinglugs.

3. Aligntheholesintheactuatorcylinderrodwiththe

holesinthecylindermountinglugsonthehorn.

4. Attachtheactuatorcylindertothehornwi thashoulder 

boltandlocknut.

Check for proper hardware alignment

CAUTION

The horn MUST pivot easily.

1. Attheatta chmentpointofthehorntothemastassembly,

useanAllenwrenchtoholdthelocknutandturnthe

shoulderboltbyhand(itshouldrotatewithoutalotof

forcebeingapplied).

2. Raisethehorn.

3. Pushthecontrolhandleawayfromthepumpassembly.

4. Ifthehornpivots

easily,tightentheshoulderboltand

locknut.

NOTE:Ifthehorndoesnotpivoteasilyornotatall,removethe

locknutandshoulderbolt.Checkallhardwareforproper

alignment.Reinstallhardw areandrepeatSTEPS1‐4.Ifalignment

problemscontinue,contacttheTechnicalSupportDepartmentat

Invacare.

FIGURE 2.2 Attach the Horn to the Mast and Actuator

Horn

Locknut

Actuator

Cylinder Rod

Cylinder Lugs

Shoulder

Bolt

Horn

Shoulder Bolt

and Steel

Washer

Locknut and

Steel Washer

Horn Bushing

Nylon

Washers

Horn Mounting Lug

(1 of 2)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comments to this Manuals

No comments

Invacare GET-U-UP LIFT User Manual Page 11

Comments to this Manuals

Related products and manuals for Communication Invacare GET-U-UP LIFT