Invacare TRACER EX2 User Manual download pdf (Page 47)

8 REAR WHEELS

Part No 1110546 47 Invacare

Tracer™ EX2 Wheelchair

Permanent Axles

1. Remove the dust cap (SA Frame only), hex screw, washer (SA

Frame only), spacer (if installed) and locknut that secure the rear

wheel to the wheelchair frame.

2. Repeat STEP 1 for the opposite rear wheel if desired.

3. To reinstall the rear wheel(s) onto the wheelchair, reverse STEPS

1-2 and torque locknut to 40 ft.-lbs.

4. Adjust wheel locks. Refer to Using/Adjusting Patient Operated

Wheel Locks on page 54.

FIGURE1 Removing/Installing Rear Wheels - Permanent Axles

8.2 Replacing/Repairing Rear Wheel Tire



WARNING

This procedure MUST be performed by a qualified technician.



If replacing the same size rear wheel, note the mounting position on the wheelchair frame for proper reinstallation of the

new rear wheel.



The spacer is used on wheelchairs with removable arms

only.

Rear Wheel

Washer

(SA Frame

ONLY)

Dust Cap

(SA Frame ONLY)

Hex Screw

Spacer (Wheelchairs

with Removable

Arms ONLY)

Wheelchair

Frame

Locknut

Axle Mounting Axle



WARNING

Replacement of the rear wheel tire MUST be performed by a qualified technician.

As with any vehicle, check the wheels and tires periodically for cracks and wear. Replace if damaged.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 63 64

No comments

Invacare TRACER EX2 User Manual Page 47